QAR: Click Here
Conditions for approval required by: Julien Gauther
Certification of Aerospace Products to international quality Standards
Certification of Aerospace Products to international quality Standards
Form restricted to registered, logged in users. Please return to the home page and use the Create Account option.
Reusability tests:
On the 1st page, it is written “Part description: M5x0.8×1.5D”
I think it is MJ5 instead of M5.
On 2nd page, could you please confirm that seating torque applied is 5,5 N.m?
What are test block material and dimensions used?
Discontinuities (EN2943, clause 5.5.1): this test is not mentioned in any documents attached. Where can we find this test result?
Many thanks in advance,
Best regard.
On the 1st page, it is written “Part description: M5x0.8×1.5D”
I think it is MJ5 instead of M5.
Acknowledged – Acceptable abbreviation, correct size stated on page 2
On 2nd page, could you please confirm that seating torque applied is 5,5 N.m?
What are test block material and dimensions used?
Confirmed 5.5 Nm is the applied seating torque (Refer to the additional documents in section 7)
Discontinuities (EN2943, clause 5.5.1): this test is not mentioned in any documents attached. Where can we find this test result?
Discontinuities are carried out in accordance table 3 of the technical spec and Bollhoff confirm no issues found.
Many thanks Phil.
It is clear.
Qualification approved on my side.
Regards.
Julien