QAR: Click Here
Conditions for approval required by: Julien Gauther
Certification of Aerospace Products to international quality Standards
Certification of Aerospace Products to international quality Standards
Form restricted to registered, logged in users. Please return to the home page and use the Create Account option.
Dear all,
In mfg flow chart, AMS2441 is called out for plating.
However, on the one hand, AMS2441 is cancelled and replaced by AMS2451/3. On the other, AMS2441 refers to nickel plating.
EN3236 and EN3237 are silver plated against EN2786.
Could you please clarify?
QTR, clause 15.2.1: maximum self-locking torque shall be 3,2 N.m and minimum breakaway torque shall be 0,35 N.m.
QTR, clause 15.2.2: installation torque shall be 13 N.m.
Hopefully, max locking-torque and min breakaway torque values below table 2 are correct.
QTR, clause 15.2.1: maximum self-locking torque shall be 6,4 N.m and minimum breakaway torque shall be 0,35 N.m.
QTR, clause 15.3.2: installation torque shall be 13 N.m.
Hopefully, max locking-torque and min breakaway torque values below table 3 are correct.
Many thanks in advance
Best regards
Julien
Issue two of the report has been uploaded to to the website to fix the Typos in section 15.2.1, 15.2.2, 15.3.1 and 15.3.2
Manufacturing route has also been corrected to call out EN2786 / AMS2411
Many thanks to you Phil and SPS Santa Ana.
All is clear for me now, so, approved from my side.
Have a nice day
Regards
Julien