QAR: Click Here
Conditions for approval required by: Julien Gauther
Certification of Aerospace Products to international quality Standards
Certification of Aerospace Products to international quality Standards
Form restricted to registered, logged in users. Please return to the home page and use the Create Account option.
QTP: ISO8788:2000 is mentioned whereas the latest issue is ISO8788:2020. Could you please clarify?
Cadmium plating: nut test report shows EN2133:2010 while cadmium plating test report is compliant to EN2133:2020. Could you please make these TR consistent?
Hardness test: in test report, hardness test requirements are in HV5 units and results are not written in “Dureté / Hardness” box.
Hopefully, results are available in “Micro / Macro” box.
Another point: is hardness test carried out by using HV5 or HRC method? (maybe HRC is not appropriate due to nut size).
Wrench engagement and squareness of bearing surface: where can we find these test results?
Many thanks in advance,
Best regards.
QTP: ISO8788:2000 is mentioned whereas the latest issue is ISO8788:2020. Could you please clarify? ==> It was a typo on the date , qualification was perform with ISO 8788: 2020. QT P was updated
Cadmium plating: nut test report shows EN2133:2010 while cadmium plating test report is compliant to EN2133:2020. Could you please make these TR consistent? ==> See TR updated enclosed
Hardness test: in test report, hardness test requirements are in HV5 units and results are not written in “Dureté / Hardness” box.
Hopefully, results are available in “Micro / Macro” box.
Another point: is hardness test carried out by using HV5 or HRC method? (maybe HRC is not appropriate due to nut size). ==> I confirm that hardness is performed with HRC method see box “micro macro box Note “
Wrench engagement and squareness of bearing surface: where can we find these test results? Wrench engagement and squareness of bearing surface were checked in the same time during the dimensional inspection . ==> We don’t note any value just conformity or non conformity.
Regards.
Nadege & Geneviève
Dear Nadège and Geneviève.
Many thanks for all these detailed answers for which I agree with.
Approved from my side,
Best regards,
Julien